Stiga 2021 Edition PARK 320 P Workshop Manual page 23

WORKSHOP MANUAL
PARK
l) Bearings
Check for abnormal noises where the bearings are. Check that there are no signs of wear or ab-
normal backlash...
m) Exhaust system
Check for cracks, leaks or other damages. Check the engine Manufacturer's Manual.
n) Electrical system
Check for damaged cables, contacts, or other devices. Check that all cables are properly secured
to the chassis and with cable ties. Check for situations between cables and chassis, which could
damage the cable and cause a short circuit.
o) Cutting deck and blades
WARNING! The blades are sharp. Always wear work gloves when working with
blades to avoid injury.
– Check for collision damages or wear on the cutting deck and paintwork. Align, repair and re-
touch the paint if necessary.
– Check the tightness of the bearing support screws and tighten if necessary.
– Rotate the blades and check that the shafts rotate correctly, are not bent, and that there are no
abnormal noises and backlashes on the bearings.
– Check the condition and tension of the belts.
– Check that the lifting mechanism moves smoothly, is not jammed, has no backlashes and that
it locks in the desired position.
– Check that the blades are sharp and, if necessary, sharpen as indicated.
p) Power Take-Off (PTO)
– Check that the electromagnetic clutch activates the work equipment in the desired time and that
it does not slip under normal load conditions. Replace the clutch if necessary.
– Verify that the PTO brake stops the rotation in the required time. Adjust if allowed by the device
type or replace.
– Check that the PTO belt activates the work equipment in the desired time and that it does not
slip under normal load conditions. Adjust if necessary.
q) Controls
Check that all controls are working correctly, that there are no jams or excessive
backlashes.
r) Test driving
If a cutting device or other equipment is provided, they must be installed before performing the
test drive with the machinery. Drive the car for a few minutes at different speeds and with repeated
left and right turns, check that everything works smoothly and correctly, without anomalies and
without vibrations or strange noises.
Check that all safety devices are properly functioning.
2 - INFORMATION FOR SERVICE CENTRES
[
Chapter
6]
EDITION PAGE
2020 23 /
124