Using The Machine - Stiga P 901 PH Operator's Manual

Service (11:E).
Battery (11:F).
Power take-off (11:G).
12V ON/OFF (11:H).
Headlight (11:I).
Maximum inclination (11:L).
Parking brake pedal (11:M).
Seat (11:N).
Oil (11:P).
• Headlight and rear attachment control (Mod. 340 IX)
(10:D and 11)
Headlight button/12V (10:E).
• Timer display (Mod. 340 X) (10:D and 11)
Timer display (11:B).
• Power take-off (10:F)
Button for engaging/disengaging power take-off.
• Rear attachment adjustment control (10:H and 10:I)
The button allows the rear attachment to be
raised and lowered.
• Rear attachment control (10:L)
Use this button to supply/disconnect power to
the attachment.
• Hydraulic attachment lifter (10:M)
Floating position.
Lowering.
Idle (centre) position.
Lifting.
• Hydraulic socket control levers (Mod. 740 IOX) (10:O
and 10:N)
The two levers control the hydraulic sockets located on the
front left side.
They have three positions:
Forward / Reverse position.
Central position
• Transmission engagement / release lever (12)
Transmission engaged =
lever out. For normal use.
Transmission released = lever in. the
machine can be moved by hand.
• Power take-off (13 and 14)
These supports allow to switch easily and
quickly from one attachment to another.
Releasing the belt tension: See figure 13.
Tensioning the belt: see figure 13 and 14.

5. USING THE MACHINE

5.1. PRELIMINARY OPERATIONS
• Filling with oil and fuel
IMPORTANT The machine is supplied without engine oil
or fuel.
Check if there is fuel and check the oil level before using the
machine. For methods and precautions on refuelling and
topping up oil, follow the instructions in the engine handbook.
• Seat adjustment
See figure 15.
• Steering wheel adjustment (9:E)
Unscrew the adjustment handle (9:D) from the steering
wheel to lift or lower it into the desired position. Tighten.
• Cutting height adjustment (10:G)
Press to increase the cutting height.
Press to decrease the cutting height.
EN - 5