Device Settings; Operation Via The Command Interface - Pepperl+Fuchs IUH-F190-V1 Series Manual

Read / write head for identcontrol

Hide thumbs Also See for IUH-F190-V1 Series:

Table of Contents

IUH-F190-V1-*

Commissioning

Country Identifiers for IUH-F190-V1-FR2

Country

Identifier

For technical details on the regional settings, see chapter 4.3. For an example of reading and

writing the country identifier, see chapter 6.3.

6.3

Device Settings

Warning!

Device not configured or configured incorrectly

Configure the device prior to commissioning. A device that has not been configured or

configured incorrectly may lead to faults in the plant.

Before commissioning the read/write head, you need to configure the control interface. To do

so, read the "Commissioning" chapter of the manual for your control interface.

Configure the read/write heads with the described system commands (see chapter 7.6.2). For

a parameterization example, see see chapter 6.4.

Caution!

Uncontrolled triggered processes

Before commissioning the device, make sure that all processes are running smoothly;

otherwise damage may occur in the plant.

6.4

This section shows you how to operate the read/write head using an IDENTControl control

interface with serial interface. The commissioning procedure described relates to the RS-232

interface and involves a PC. The examples include the syntax for coding the commands and

parameters via the Ethernet TCP/IP and PROFIBUS/PROFINET interfaces. Further details

about these codes and the factory settings for your IDENTControl control interface can be

found in the manual.

Occupied Frequency Bandwidth

Frequency Access Method

902 MHz ... 928 MHz