Pepperl+Fuchs IUH-F190-V1 Series Manual page 57

IUH-F190-V1-*
Operation
The serial response .30.31.80.02 indicates the country identifier for the IUH-F190-V1-FR2-02,
which is set by the manufacturer. You cannot change this country identifier.
Reset to Default, RD
This parameter returns all settings of the read/write head to the default configuration. The
parameter RC remains unchanged.
ParamTyp: RD
Example:
WP1URD.00.00
Default Value Parameters
Abbre-
viation Parameters
AP Antenna Polarization AP
CD Transmission Channels
E5 Number of unsuccessful attempts up to
Status 5
FL Read Out Filter Mask
IF Output Additional Information
MB Memory Bank
MD Retrieve Additional Information MD
MF Measurement of Reflected Transmission
Power
NC Number of Channels
NT Search Algorithm Cancellation Criteria
PT Power Transmit
QV Protocol Mode QV
QW Q Value
RC Country Identifier, "Region Code"
RD Reset to Default
SM Transmission Pauses in "Sensing Mode" 0
TA Number of Attempts, "Tries Allowed" TA
Transmission Pauses in "Sensing Mode" SM
The parameter SM defines a pause time in milliseconds. This pause time is executed once all
runs are complete.
This parameter is especially useful for continuous operation with "enhanced" commands (see
chapter 7.4). If you specify transmission pauses, you can operate the read/write head at higher
ambient temperatures.
ParamTyp: SM
Default: SM = .00.00
Value range: 0 ms ... 65535 ms, 2 bytes
Example:
WP1USM.00.02.27.10 sets the pause time to 10,000 ms = 10 seconds.
RP1USM.00.00 outputs the pause time.
Default value
Right-handed circular (R)
Depends on country identifier, see
chapter 4.3
5
No filter set (0)
Off (0)
User Memory (3)
Not applicable
Not applicable
Depends on country identifier, see
chapter 4.3
Off (255)
Depends on country identifier, see
chapter 4.3
Multiframe Protocol (M)
2
Not applicable
Not applicable
2
57