Countries Of Use; European Union; Argentina; Australia - Pepperl+Fuchs IUH-F190-V1 Series Manual

IUH-F190-V1-*
Product Description
4.3

Countries of Use

Note!
Country Identifier
All IUH-F190-V1-* read/write heads operate within their maximum frequency range with the
appropriate settings for the relevant country. You must set the correct country identifier when
commissioning for the first time. See chapter 6.2.
Note!
If you wish to use the IUH-F190-V1-* read/write head in a country not included in this chapter,
make sure the relevant values for the read/write head are consistent with the local conditions
before use.
The country identifier also defines the frequency access method used.
Frequency Access Method
A frequency hopping spread spectrum is used in the United States and China. See
■
chapter 4.2.7. The number and position of the frequencies is fixed and cannot be
changed by the user. All channels are used.
A programmable frequency list is used in other countries, including the European Union,
■
Singapore, Vietnam, and India. You can compile this frequency list from a specified set of
channels. Four channels are specified in the European Union as appropriate for dense
reader mode in accordance with EN 302208. See chapter 4.2.6. When selecting this
country identifier, you can configure one or more channels, or all four channels.
4.3.1

European Union

In the European Union, the use of RFID in the UHF range is regulated by EN 302208.
UHF wavelength: 865 MHz ... 868 MHz
■
Radiated power: 30 mW ... 300 mW
■
Radiated power: 20 mW ... 200 mW
Channel bandwidth: 200 kHz
■
Channel spacing: 600 kHz
■
Frequency access method: programmable frequency list
■
Number of predefined channels: 4
■
Programmable channels: 4, 7, 10, 13
Center frequencies: 865.7 MHz, 866.3 MHz, 866.9 MHz, 867.5 MHz
Up to 4 channels can be parameterized and used in sequence.
Default: dense reader mode on channel 4, 10, 7, 13. See chapter 4.2.6.
4.3.2

Argentina

The regulations for the UHF frequency range in Argentina are the same as the regulations for
the UHF frequency range in the USA. See chapter 4.3.18.
4.3.3

Australia

In Australia, the use of RFID in the UHF range is regulated as follows:
UHF wavelength: 920 MHz ... 926 MHz
■
Radiated power: 50 mW ... 500 mW
■
Channel bandwidth: 500 kHz
■
Channel spacing: 500 kHz
■
Frequency access method: frequency hopping spread spectrum. See chapter 4.2.7.
■
; Default = 50 mW
ERP ERP
; Default = 50 mW
ERP ERP
; Default = 125 mW
EIRP EIRP
(IUH-F190-V1-FR1)
(IUH-F190-V1-EU)
(IUH-F190-V1-FR2)
17