Pepperl+Fuchs IUH-F190-V1 Series Manual page 35

IUH-F190-V1-*
Commissioning
Example:
In the examples below, the read/write head is connected to channel 1 of the control interface.
The outputs follow the multiframe protocol, see table "Responses Depending on Protocol
Mode QV" on page 55.
Reading the Country Identifier
Read Parameter RC
Use the read parameter RC command to read out the read/write head's country identifier:
Command:
Confirmation:
Response:
Table 6.1
The country identifier set on the read/write head is 01, where 01 corresponds to the country
identifier for the European Union.
Writing the Country Identifier
Write Parameter RC
Use the write parameter RC command to change the country identifier on the read/write head
to 04 (= India).
Command:
Confirmation:
Response:
Table 6.2
Reading Tags
Enhanced Read Read-Only Code
Send the enhanced read read-only code command to the read/write head. The "RF ON" LED
on the read/write head lights up blue.
Command:
Confirmation:
Response:
Table 6.3
Move a tag into the read/write head's measurement range. When the tag has been detected
and the read-only code has been read out, the "READ / WRITE" LED on the read/write head
lights up yellow. The read-only code is displayed in the terminal program.
Serial Ethernet
RP1URC.00.00 .00.0A.BE.03.00.55.52.43.
00.00
- .00.06.BE.03.FF.3E
.30.31.00.01 .00.0A.BE.03.00.3F.00.02.
00.01
Read Parameter RC
Serial Ethernet
WP1URC.00.02. .00.0C.BF.03.00.55.52.43.
00.04 00.02.00.04
- .00.06.BF.03.FF.11
.30.31 .00.06.BF.03.00.12
Write Parameter RC
Serial Ethernet
EF1 .00.04.1D.03
- .00.06.1D.03.FF.0B
.35.31 .00.06.1D.03.05.0C
Enhanced read read-only code, no tag in the measurement range
PROFIBUS/PROFINET
.BE.03.00.55.52.43.00.00
.BE.03.FF.3E
.BE.03.00.3F.00.02.00.01
PROFIBUS/PROFINET
.BF.03.00.55.52.43.00.02.
00.04
.BF.03.FF.11
.BF.03.00.12
PROFIBUS/PROFINET
.1D.03
.1D.03.FF.0B
.1D.03.05.0C
35