Crankshaft Position Sensor - Remove And Install - Perkins 1106C Series Disassembly And Assembly

KENR6932
•
Ensure that the backs of the bearings and the
bores are clean and dry.
•
Ensure that the bearing locking tabs are properly
seated in the tab grooves.
•
The crankshaft must be free of oil at the contact
points of Tooling (A).
1. Put a piece of Tooling (A) on the crown of the
bearing that is in the cap.
Note: Do not allow Tooling (A) to extend over the
edge of the bearing.
2. Use the correct torque-turn specifications in order
to install the bearing cap. Do not use an impact
wrench. Be careful not to dislodge the bearing
when the cap is installed.
Note: Do not turn the crankshaft when Tooling (A)
is installed.
3. Carefully remove the cap, but do not remove
Tooling (A). Measure the width of Tooling (A)
while Tooling (A) is in the bearing cap or on the
crankshaft journal. Refer to Illustration 333.
Illustration 333
Typical Example
4. Remove all of Tooling (A) before you install the
bearing cap.
Note: When Tooling (A) is used, the readings can
sometimes be unclear. For example, all parts of
Tooling (A) are not the same width. Measure the
major width in order to ensure that the parts are
within the specification range. Refer to Specifications
Manual, "Connecting Rod Bearing Journal" and
Specifications Manual, "Main Bearing Journal" for the
correct clearances.
Crankshaft Position Sensor -
Remove and Install
Removal Procedure
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 334
1. Slide locking tab (1) into the unlocked position.
2. Disconnect harness assembly (2) from position
sensor (3).
3. Remove bolt (4).
4. Carefully remove position sensor (3) from the
cylinder block.
Note: Do not use a lever to remove the position
sensor from the cylinder block.
5. Remove O-ring seal (5) from position sensor (3).
g01152855
Installation Procedure
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Disassembly and Assembly Section
NOTICE
NOTICE
165
i02654468
g01341527