Perkins 1106C Series Disassembly And Assembly page 16

16
Disassembly and Assembly Section
Illustration 20
1. Loosely install tube clips (12) and the allen head
screws (13) to the fuel injection line (6).
2. Place fuel injection line (6) in position.
3. Remove the caps from the port in fuel injection
pump (7) and from the appropriate port in fuel
manifold (4). Remove the caps from new fuel
injection line (6).
4. Loosely connect the nuts at both ends of fuel
injection line (6), to fuel manifold (4) and to fuel
injection pump (7). Ensure that the ends of the
fuel injection line are correctly seated in the fuel
injection pump and in the fuel manifold.
5. Use Tooling (A) to tighten the nuts on fuel injection
line (6) to a torque of 30 N·m (22 lb ft).
6. Install the bolts (11) for tube clips (12) that secure
fuel injection line (6). Tighten bolts (11) to a torque
of 22 N·m (16 lb ft). Tighten allen head screws (13)
to a torque of 10 N·m (89 lb in). Ensure that fuel
injection line does not contact any other engine
component.
g01335195
Illustration 21
Typical example
7. Connect harness assembly (8) to position sensor
(10). Slide locking tab (9) into the locked position.
Connect harness assembly (8) to fuel injection
pump (7).
Illustration 22
Typical example
8. Install a new seal (5) to electronic unit injector (1).
Ensure that the flange on the seal is flush with the
valve mechanism cover base.
9. Remove the caps from the port of electronic unit
injector (1) and from the appropriate port in fuel
manifold (4).
KENR6932
g01335194
g01335193