Ecm Mounting Bracket - Remove And Install - Perkins 1106C Series Disassembly And Assembly

178
Disassembly and Assembly Section
Illustration 359
Typical example
6. Remove the plugs from plastic tube assemblies
(4) and (11). If necessary, remove the caps from
the connectors in the electronic control module.
Connect plastic tube assemblies (4) and (11).
7. Connect engine wiring harness (7) to electronic
control module (5). Tighten the fastener (8) to a
torque of 5 N·m (3 lb ft).
Note: Care must be taken in order to avoid damage to
the connector pins during installation of the harness.
8. Position the assembly of the engine wiring harness
onto brackets (14) and (16). Use new cable straps
(1), (9) and (10) in order to secure the harness
assembly to the brackets.
9. Connect OEM wiring harness (2) to electronic
control module (5). Tighten fastener (6) to a torque
of 5 N·m (3 lb ft).
Note: Care must be taken in order to avoid damage to
the connector pins during installation of the harness.
10. Use a new cable strap (3) in order to secure the
harness assembly.
11. Restore the fuel supply to the engine.
12. Restore the electrical supply to the engine.
13. Remove the air from the fuel system. Refer to
Operation and Maintenance Manual, "Fuel System
- Prime".
ECM Mounting Bracket -
Remove and Install
Removal Procedure
Start By:
a. Remove the electronic control module. Refer to
Disassembly and Assembly, "Electronic Control
Module - Remove and Install".
g01341877
Illustration 360
1. Follow Steps 1.a through 1.c in order to disconnect
engine wiring harness (2) .
a. Slide locking tab (4) into the unlocked position.
b. Disconnect harness assembly (2) from fuel
pressure sensor (3).
c. Cut cable straps (1) and (5). Position harness
assembly (2) so that the harness assembly is
clear of mounting bracket (8).
2. Disconnect wire (7) for the glow plugs. Remove
terminal insulator (6) from mounting bracket (8).
Refer to Disassembly and Assembly, "Glow Plugs
- Remove and Install" for the correct procedure.
KENR6932
i02654477
g01342045