Turbocharger - Install (Turbocharger Top Mounted) - Perkins 1106C Series Disassembly And Assembly

38
Disassembly and Assembly Section
Illustration 67
1. Install actuator (6) to bracket (3). Install nuts (5)
to bracket (3).
2. Tighten the nuts to a torque of 5 N·m (44 lb in).
3. Connect the bottom of actuator (6) to a suitable air
supply with an accurate gauge.
4. Operate the arm of the actuator by hand in order
to check that the valve is free to move.
5. Push the arm of the wastegate valve toward
actuator (6) and hold the arm in position. Slowly
apply air pressure to actuator (6) until pin (2) will
fit into actuator rod (4). Install circlip (1) into the
groove in pin (2).
Note: Do not apply an air pressure of more than
205 kPa (29 psi) to the actuator. High pressures may
damage the actuator.
6. Install the pipe for boost pressure (7) to actuator
(6).
End By:
a. To check the wastegate actuator for correct
operation, refer to System Operation, Testing and
Adjusting, "Turbocharger - Inspect".
Turbocharger - Install
(Turbocharger Top Mounted)
Installation Procedure
Table 11
Tool
g01335760
218200221
A
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 68
Typical example
1. Ensure that the turbocharger is clean and free
from damage. Inspect the turbocharger for wear.
Refer to System Operation, Testing and Adjusting,
"Turbocharger Inspect" for more information. If the
turbocharger is worn, the complete turbocharger
must be replaced.
Required Tools
Part
Part Description
Number
POWERPART
Rubber Grease
NOTICE
KENR6932
i02654360
Qty
1
g01335496