Flywheel - Remove - Perkins 1106C Series Disassembly And Assembly

72
Disassembly and Assembly Section
Illustration 124
Typical example
5. Remove O-ring seal (3) from water temperature
regulator housing (2).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that all components of water temperature
regulator housing (2) are clean and free of wear or
damage. Check the water temperature regulator
for correct operation. Refer to System Operation,
Testing and Adjusting, "Water Temperature
Regulator - Test" for the procedure to test the
water temperature regulator. If any components
of the water temperature regulator housing are
worn or damaged, the complete assembly must
be replaced.
Illustration 125
Typical example
2. If the original water temperature regulator housing
is installed, position a new O-ring seal (3) into the
groove in water temperature regulator housing (2).
A new water temperature regulator housing is
supplied with a new O-ring seal.
3. Install water temperature regulator housing (2) to
the cylinder head.
Note: Ensure the correct orientation of the water
temperature regulator housing.
g01336667
Illustration 126
Typical example
4. Install bolts (1). Tighten bolts (1) to a torque of
44 N·m (32.5 lb ft).
5. Connect the upper radiator hose and tighten the
hose clamps.
6. Fill the cooling system to the correct level. Refer
to Operation and Maintenance Manual, "Cooling
System Coolant - Check" and Operation and
Maintenance Manual, "Cooling System Coolant -
Change" for the correct filling procedure.

Flywheel - Remove

Removal Procedure
Table 23
Tool
A
g01336667
Start By:
a. Remove the electric starting motor. Refer to
Disassembly and Assembly, "Electric Starting
Motor - Remove and Install".
Required Tools
Part
Number Part Description
Guide Stud
-
(1/2 inch - UNF by 4
inch)
KENR6932
g01336665
i02654493
Qty
2