Flywheel Housing - Remove And Install (Wet Back End Housing) - Perkins 1106C Series Disassembly And Assembly

KENR6932
Illustration 142
Typical example
6. Install a suitable lifting device to the flywheel
housing. The flywheel housing can weigh 32 kg
(70.5 lb).
7. Use the lifting device to align flywheel housing (1)
with Tooling (A). Install the flywheel housing to the
cylinder block.
8. Install bolts (2) and bolts (3).
9. Remove Tooling (A). Install remaining bolts (3).
10. Tighten bolts (3) to a torque of 63 N·m (46 lb ft).
11. Tighten bolts (2) to a torque of 78 N·m (57.5 lb ft).
12. Check the alignment of flywheel housing (1) with
the crankshaft. Refer to System Operation, Testing
and Adjusting, "Flywheel Housing - Inspect".
End By:
a. Install the flywheel. Refer to Disassembly and
Assembly, "Flywheel - Install".
Flywheel Housing - Remove
and Install
(Wet Back End Housing)
Removal Procedure
Start By:
a. Remove the flywheel. Refer to Disassembly and
Assembly, "Flywheel - Remove".
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01337563
1. Install a suitable lifting device to the flywheel
housing in order to support the flywheel housing.
The flywheel housing can weigh 32 kg (70.5 lb).
Illustration 143
Typical example
2. Remove bolts (2). Remove bolts (4). Remove
bolts (3) from flywheel housing (1).
3. Use the lifting device in order to remove flywheel
housing (1) from the cylinder block.
Disassembly and Assembly Section
NOTICE
81
i02654369
g01337602