Perkins 1106C Series Disassembly And Assembly page 28

28
Disassembly and Assembly Section
Illustration 46
Typical example
12. Remove sealing washer (14) . Ensure that the
sealing washer is removed from the cylinder head.
Remove O-ring seal (15) from the electronic unit
injector.
Alternative Removal Procedure
Table 8
Required Tools
Part
Tool Number
27610307
A T40 Torx Socket
B 27610288 Pry Bar
Start By:
a. Remove the rocker shaft assembly. Refer to
Disassembly and Assembly, "Rocker Shaft -
Remove".
b. Remove the fuel injection lines. Refer to
Disassembly and Assembly, "Fuel Injecton Lines
- Remove".
Note: This is an optional procedure to remove the
electronic unit injectors. The method should ONLY be
used when all electronic unit injectors are removed
and when the engine is removed from the application.
Contact with high pressure fuel may cause fluid
penetration and burn hazards. High pressure fu-
el spray may cause a fire hazard. Failure to fol-
low these inspection, maintenance and service in-
structions may cause personal injury or death.
g01255701
Part Name Qty
1
1
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorised personnel that have the correct train-
ing.
Before begining ANY work on the fuel system, re-
fer to Operation and Maintenance Manual, "Gen-
eral Hazard Information and High Pressure Fuel
Lines" for safety information.
Refer to Systems Operation, Testing and Adjust-
ing Manual, "Cleanliness of Fuel System Compo-
nents" for detailed information on the standards
of cleanliness that must be observed during ALL
work on the fuel system.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
NOTICE
Use a deep socket in order to remove the electrical
connections from the electronic unit injectors. Use of
incorrect tooling will result in damage to the electronic
unit injectors.
Note: Put identification marks on all hoses, on all
hose assemblies, on wires and on all tube assemblies
for installation purposes. Plug all hose assemblies
and tube assemblies. This helps to prevent fluid loss
and this helps to keep contaminants from entering
the system.
1. Isolate the fuel supply to the engine.
2. Isolate the electrical supply to the engine.
KENR6932