Inlet And Exhaust Valve Springs - Remove And Install - Perkins 1106C Series Disassembly And Assembly

50
Disassembly and Assembly Section
5. Apply Tooling (A) to bolts (5). Install the bolts to
inlet manifold (4).
Illustration 88
6. Tighten the bolts to a torque of 22 N·m (16 lb ft) in
the sequence that is shown in Illustration 88.
7. Ensure that inlet connection (2) is clean and
free from damage. If necessary, replace the inlet
connection.
8. Position a new gasket (3) onto the inlet manifold.
Install inlet connection (2) to inlet manifold (4).
9. Install bolts (1) to inlet connection (2). Tighten the
bolts to a torque of 22 N·m (16 lb ft).
10. Install the air temperature sensor. Refer
to Disassembly and Assembly, "Inlet Air
Temperature Sensor - Remove and Install".
11. Install the boost pressure sensor. Refer to
Disassembly and Assembly, "Boost Pressure
Sensor - Remove and Install".
12. Position the harness assembly on the inlet
manifold. Use new cable straps in order to secure
the harness assembly.
13. Connect the breather hose to the separator for
the crankcase breather (not shown). Refer to
Disassembly and Assembly, "Crankcase Breather
- Install".
14. If the engine is equipped with a cover over the
fuel system this will need to be installed.
End By:
a. Install the ECM mounting bracket. Refer to
Disassembly and Assembly, "ECM Mounting
Bracket - Remove and Install".
b. Install the fuel manifold. Refer to Disassembly and
Assembly, "Fuel Manifold - Install".
c. If necessary, install the fuel filter base. Refer to
Disassembly and Assembly, "Fuel Filter Base -
Remove and Install".
Inlet and Exhaust Valve
Springs - Remove and Install
Removal Procedure
Table 16
Required Tools
Part
Tool
Number
-
A
Circlip Pliers
21825739
Valve Spring Compressor
27610235
B Adapter
27610295
Head
21825576
C Crankshaft Turning Tool
27610291
Barring Device Housing
C
27610289
Gear
Start By:
a. Remove the rocker shaft assembly. Refer to
Disassembly and Assembly, "Rocker Shaft and
Pushrod - Remove".
Note: Either Tooling (A) can be used. Use the Tooling
that is most suitable.
KENR6932
g01335892
i02654522
Part Description Qty
1
1
1
1
1
1
1