Perkins 1106C Series Disassembly And Assembly page 14

14
Disassembly and Assembly Section
Illustration 15
4. Remove plastic clamps (3) from the fuel injection
lines (2).
5. Slide the dust seal from the nut on the fuel
injection.
6. Disconnect fuel injection line (2) from electronic
unit injector (1).
7. Disconnect fuel injection line (2) from fuel manifold
(4).
8. Remove fuel injection line (2). Discard the fuel
injection line.
9. Plug the open port in fuel manifold (4) immediately.
Use Tooling (A) in order to plug the open port in
the fuel manifold.
10. Remove seal (5) from electronic unit injector (1)
and the base of the valve mechanism cover.
11. Plug the open port in electronic unit injector (1)
immediately. Use Tooling (A) in order to plug the
open port in the electronic unit injector.
12. Repeat Steps 5 through 12 in order to remove
the remaining fuel injection lines from the fuel
manifold to the electronic unit injectors.
g01335193
Illustration 16
Typical Example
13. If necessary, disconnect harness assembly
(8) from fuel injection pump (7). Slide locking
tab (9) into the unlocked position. Disconnect
harness assembly (8) from position sensor (10).
Position harness assembly (8) so that the harness
assembly is clear of fuel injection line (7).
Illustration 17
KENR6932
g01335194
g01335195