Perkins 1106C Series Disassembly And Assembly page 142

142
Disassembly and Assembly Section
Illustration 287
(X) Position of guide studs.
(Z) Position of short isolating screws.
6. Tighten the isolating screws to a torque of 22 N·m
(16 lb ft). Tighten the isolating screws in the
sequence that is shown in Illustration 287.
7. Remove Tooling (A).
Illustration 288
8. Install the four remaining isolating screws. Tighten
the isolating screws to a torque of 22 N·m (16 lb ft).
Tighten the isolating screws in the sequence that
is shown in Illustration 288.
9. Install a new O-ring seal (6) to the drain plug (5).
Install the drain plug (5) to the engine oil pan (7).
Refer to Illustration 286. Tighten the oil drain plug
to a torque of 34 N·m (25 lb ft).
KENR6932
g01340724
g01340725