Housing (Front) - Remove - Perkins 1106C Series Disassembly And Assembly

98
Disassembly and Assembly Section
11. Use Tooling (C) in order to check the end play for
the heavy-duty idler gear. Refer to Specifications,
"Gear Group (Front)" for more information.
Illustration 186
Checking backlash
12. Check the backlash between the idler gear and
the camshaft gear. Refer to Specifications, "Gear
Group (Front)" for more information.
13. Check the backlash between the idler gear and
the crankshaft gear. Refer to Specifications, "Gear
Group (Front)" for more information.
14. Lightly lubricate all of the gears with clean engine
oil.
End By:
a. Install the fuel injection pump gear. Refer to
Disassembly and Assembly, "Fuel Pump Gear -
Install".

Housing (Front) - Remove

Removal Procedure
Start By:
a. Remove the fan. Refer to Disassembly and
Assembly, "Fan - Remove and Install".
b. If necessary, remove the alternator. Refer
to Disassembly and Assembly, "Alternator -
Remove".
c. Remove the front pulley. Refer to Disassembly
and Assembly, "Vibration Damper and Pulley -
Remove".
d. Remove the engine oil pan. Refer to Disassembly
and Assembly, "Engine Oil Pan - Remove".
e. If the engine has an accessory drive, remove
the accessory drive. Refer to Disassembly and
Assembly, "Accessory Drive - Remove and
Install".
f. Drain the coolant into a suitable container for
storage or disposal. Refer to Operation and
Maintenance Manual, "Cooling System Coolant -
Drain" for the correct procedure.
g. Remove the timing gears. Refer to Disassembly
and Assembly, "Gear Group (Front) - Remove
and Install".
h. Remove the fuel injection pump. Refer to
g01335426
Disassembly and Assembly, "Fuel Injection Pump
- Remove".
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
i02654518
Illustration 187
1. Remove bolts (1) that secure bypass tube (2) to
front housing (3). Remove bypass tube (2) from
the cylinder head. Remove O-rings (4) and (5)
from bypass tube (2).
KENR6932
NOTICE
NOTICE
g01337982