Perkins 1106C Series Disassembly And Assembly page 18

18
Disassembly and Assembly Section
Illustration 23
Typical example
Illustration 24
Typical example
6. Place a suitable container below fuel injection
pump (1) in order to catch any fuel that might be
spilled.
7. Disconnect plastic tube assembly (2) from fuel
injection pump (1).
8. Disconnect harness assembly (7) from solenoid
(3) of the fuel injection pump. Disconnect engine
wiring harness (7) from position sensor (4) for the
fuel injection pump.
Note: The harness assembly should be positioned
in order to avoid an obstruction to the fuel injection
pump.
9. Remove plastic tube assembly (11) from fuel
transfer pump (8).
10. Disconnect plastic tube assembly (10) from the
outlet of fuel transfer pump (8).
11. Disconnect plastic tube assembly (5) from fuel
injection pump (1).
12. Remove tube assembly (12) for the fuel return
from the fuel transfer pump and the cylinder head.
g01335253
Note: Disconnect the tube assembly at the fuel
transfer pump first in order to drain the fuel from the
cylinder head.
13. Remove tube assembly (9) for the engine oil
supply to fuel injection pump (1).
14. Plug or cap all open ports and tube assemblies
immediately with new plugs or caps.
15. Remove fuel injection line (6) that connects the
fuel injection pump to the fuel manifold. Refer to
Disassembly and Assembly, "Fuel Injection Lines
- Remove". Use Tooling (D) in order to plug the
open ports in the fuel injection pump and in the
fuel manifold. Discard the fuel injection line.
g01335254
KENR6932