Safety Precautions - Olympus BXFM Instructions Manual

Safety precautions

If the product is used in a manner not specified by this manual, the safety of the user may be imperiled. In addition, the
product may also be damaged. Always use the product according to this instruction manual.
The following symbols are used in this instruction manual.
CAUTION
NOTE
TIP
CAUTION - Installation of the product -
Combination of U-ST and U-KMAS
Settable
range
Combination of SZ-STL and BX3M-ILH
2
: Indicates a potentially hazardous situation which, if not avoided, may result in
minor or moderate injury.
: Indicates a potentially hazardous situation which, if not avoided, may result in
damage to the product or other property.
: Indicates the useful knowledge or information for use.
Install the microscope on a sturdy, level table or bench.
Prevent the microscope from overturning.
Back
Attach each unit at the appropriate angle.
· If you use the BXFM system in combination with the stand (U-ST),
Front
· When using the BXFM system in combination with the large stand
If you install the microscope on an unstable table or a tilted table, the
microscope may drop and you may get injured.
The microscope becomes unstable if the height of the microscope
is increased by the accessories mounted on it. In this case, as this
microscope may be overturned, take the actions to prevent the
microscope from overturning.
attach the BXFM frame (BXFM-F) at within ±30 degrees with respect to
the column. Also, attach the reflected light illuminator for BF (U-KMAS)
so that the lamp housing comes to the right side when viewed from
the front.
(SZ-STL) and the illuminator holder for BXFM (BX3M-ILH), set the
attaching angle of the BXFM frame (BXFM-F) in the range where the
center position of the objective used for observation is placed inside
from the both edges of the large stand by 50mm.