Olympus BXFM Instructions Manual page 76

2
3
4
70
10
Attaching the nosepiece
1
1
Turn the coarse focusing knob to lower the BXFM frame sufficiently.
2
Loosen the nosepiece clamping screw using the Allen screwdriver.
NOTE
3
Insert the nosepiece from the front side along the nosepiece mounting
dovetail of the reflected light illuminator, and push it until it touches the end.
4
Hold the Allen screwdriver between the pointing finger and the thumb,
and tighten the nosepiece clamping screw to secure the nosepiece.
Attaching the coded nosepiece
5
Connect the cable to the connector of the control box for coded
function (U-CBS).
NOTE
Be careful, if the clamping screw is loosened too much, it
may be come off.
· When attaching or detaching the nosepiece attached with
the cable, be sure to remove the cable from the connector
in advance.
· If you want to change the nosepiece to the motorized
nosepiece when using the system combined with the
manual nosepiece, remove the reflected light illuminator
together when removing
In order to combine the motorized nosepiece, the cable
for motorized nosepiece (BX3M-RMCBL) must be attached
before attaching the reflected light illuminator. For details,
see "Attaching the cable for motorized nosepiece" (page 66).
For connection of the cable of coded nosepiece with the
control box for coded function (U-CBS), refer to the instruction
manual provided with the U-CBS.
the manual nosepiece.