Software; Update Software - Universal Robots UR10 Service Manual

4. Software

4.1 Update software

Universal Robots software is named PolyScope.
This software can be updated, when new software releases become available.
When updating software from an older version, updates must be installed sequentially.
If it ain't broke, don't fix it:
If a robot is operating in an existing application, Universal Robots do not recommend updating software,
unless the use of new functions in a newer software release is required for this application.
IMPORTANT NOTICE:

Software should only be updated after consulting Distributor from which the robot has been
purchased or after consulting Universal Robots if representing a Distributor.

Universal Robots do not recommend updating software without proper instruction in how to carry
out updates.

When updating firmware controller power MUST NOT be turned off during update.Universal

Robots can by no means be held responsible for any failed update caused by improper
operation.Universal Robots can by no means be held responsible for any failed update caused by
improper operation.
Go to www.support.universal-robots.com/download
A login is required, which is only available to Distributors.
Please note: If representing an end customer, contact the Distributor from which the robot has been
purchased to request software updates.
Instructions to updat software:

Download software update. Carefully read requirements on support site relating to which software
must be installed on robot prior to updating to the downloaded version.

Save it in the root folder on a USB-stick.

Insert USB-stick into USB-connector on right-hand side of teach pendant.

Go to main screen of PolyScope.
All rights reserved
to download software updates.
52 Servicemanual_UR10_en_3.1.1