System-System Settings-Maintenance; System-System Setting-User - Bolin Technology EX1000 Series User Manual

System-System Settings-Maintenance

The Maintenance tab under the System Setting section can be used to perform the following functions:
•
Firmware Update
You can upgrade IP Encoder software and
FPGA software via this Firmware Update
feature.
o
Two types of firmware can be
upgraded from this section:
▪
Firmware for IP encoder.
The name of the file
shown as "CAM-00-IP4K-
xxx.dat"
▪
Firmware for FPGA. The
name of the file shown as
"CAM-00-FPGA-xxx.dat"
o
A firmware file can be obtained
from BOLIN Technology website:
www.bolintechnology.com
Click the Browse button, and navigate to the file (xx... .dat)
o
o
Click Remote Update, and allow the camera to load the new firmware
o
It takes a few minutes for the camera to finish the upgrade.
▪
When upgrading IP Encoder FW, it takes about 3 minutes to finish the upgrade process, prompt
shown to confirm the reboot, it takes about 1.5-2 minutes to complete the reboot. refresh the IE
browser.
▪
When upgrading FPGA FW, it takes about 3 minutes to finish the upgrade process, there is a
prompt shown to confirm the system restart. After confirm the system restart, must do power
cycle to the camera to complete the FPGA fw upgrade.
NOTE:
For MCU version upgrade, please refer to "Upgrading MCU Firmware" in User Manual Part 1.
o
•
Device Restart
o
Soft reboot, only restart the IP
encoding board. When there is a
problem with the IP interface or
the IP output, you can try to
restart the encoding board;
o
Supports auto restart and
manual restart mode;
o
Auto Restart can be configured as Never, Per day, Per week, Per month, what you have to do is just
select an option and click Enter button to make it available.
o
Manual Restart is just to click the Manual Restart Device button, and the camera encoding board will
going to restart immediately.
•
Default Setting
o
Reset All, to restore all IP interface settings to default, login password will also be restored to default
admin, but the network IP address will not be restored.

System-System Setting-User

This setting page is to allow administrator to create / manage user accounts and passwords
To add a new user:
1. Click the Add User button
2. Enter the username
3. Enter the new password in the
Password field
4. Re-enter the password in the
Repeat Password field
5. Assign role to this account, it can be
Administrator, or Operator.
6. Authorize to this account, you can
21