Table of Contents
Advertisement
Trace:
A Trace is a series of presets, recalled in a given order. This causes the camera to
iterate through the series, moving to each preset in the selected order, support create
8 traces at maximum.
To create a new trace:
1. Select Trace in the PTZ Setting bar
2. Click Create button, it will extend trace number and name field.
3. Select a number and create a name, or just by default name trace 1
4. Then click Start button
Scanning:
Left limit and right limit can be programmed, then camera image (pan) can be set to
move horizontally from left limit to right limit or from right limit to left limit
continuously.
Moving speed can be programmed, speed level from 1-8 adjustable.
Power On Action:
To set actions that the camera will take after the camera is powered on.
You can select the action as preset, patrol, scanning and cruise.
Cruise:
To record a series of camera movements that are pulled by an operator, this series of
movements is called Cruise. You can recall the cruise that has been made, the camera
will re-act all the movements within the cruise.
Fast Setting
Fast setting page can quickly navigate to Device, Network,
Video, Codec and User pages, to set corresponding parameters.
Device: The basic product information of the camera, you can
get the model number, serial number as well as the IP firmware
version information. The IP firmware version may be required
when you submit a camera issue.
Network: The network tab is where the user is able to
configure the camera IP network setting, DHCP or static IP,
including IP address, mask, gateway and DNS server.
Codec: This interface allows user to configure the Main, Sub,
Third video stream parameters, such as the resolution, bitrate
and video compression.
User: This page allows the administrator to create/manage user
accounts and passwords
10
Advertisement
Table of Contents
