Table of Contents
Advertisement
Part Two: Network Camera User Manual
Network Connection
Before accessing a network camera (also known as IP Camera or IPC) from a PC, you need to connect the
network camera to the PC directly with a network cable or via a switch or router.
Use a Shielded Twisted Pair (STP) cable to connect the network interfaces of the network camera and the PC.
Use Shielded Twisted Pair (STP) cables to connect the network interfaces of the camera and the switch or router.
Login Preparation
After you have completed the installation in accordance with the quick guide, connect the camera to power to boot
it. After the camera is booted, you can access the camera from a PC client using or a Video Management System
(VMS).
Browser Edge, Chrome, Firefox and Safari, Internet Explorer 11 browser is supported
The following uses Internet Explorer 11 on a Microsoft Windows 10 operating system as an example.
Check before login
The camera is powered on and connected to the network switch
⚫
The camera's IP address is located within the same subnet as the PC
⚫
The PC is connected to the network switch
⚫
The PC's IP address is located within the same subnet as the camera
⚫
The PC is installed with Browser (Edge, Chrome, Firefox, Safari and Internet Explorer 11)
⚫
Use default video format setting or set the camera video format to 1080P30 or 1080P25 using RS485 keyboard
⚫
(Refer to camera setting menu).
6
Advertisement
Table of Contents
