Dip Switch Settings - Bolin Technology D Series Manual

DIP SWITCH SETTINGS

The Dip switch is for setting the camera configuration for following items:
1. Camera ID Address for VISCA protocol
2. RS-232 / RS-422 control method selection
3. RS-232 / RS-422 baud rate selection
Setting of the DIP Switches
Turn off power to the camera before changing the DIP switch settings.
Power on the camera to have the new Dip Switch setting activated.
Camera ID address and Baud rate setting can be set in camera's OSD menu as well. The camera accepts
both the changes of OSD menu setting or changes of the DIP switch setting. They override each other. After
the camera is turned on, the camera takes the last setting before it is turned on, either through the OSD or
rear panel DIP switch.
The DIP Switch Settings
Bit 1~3: Camera Address setting for VISCA protocol
Bit 4: Reserved
Bit 5: Reserved
Bit 6: RS-232/RS-422
Bit 7~8: RS-232/RS-422 Baud Rate
25