Table of Contents
Advertisement
BOTTOM DIP SWITCH SETTINGS
The bottom dip switch is for setting the camera configuration for following items:
1. Camera ID Address for VISCA protocol
2. Video output / Video color space
3. RS-232 / RS-422/485 selection
4. Video resolutions selection
5. IR remote controller ID
Setting of the BOTTOM DIP Switches
Turn off power to the camera before changing the DIP switch settings.
Power on the camera to have the new Dip Switch setting activated.
From the above list, The NO.1 Camera ID address is for VISCA protocol up to 7. The camera ID address for PELCO P/D
protocol can be set on camera OSD menu. NO.2 Video resolution settings can be set in camera OSD menu as well. The
camera takes either the way of OSD menu setting or the way of bottom DIP switch setting. They override each other.
After the camera is turned on, the camera takes the last setting before it is turned on, either set through the OSD or
bottom DIP switch.
The DIP Switch Settings
SW 1:
Factory Default Setting, OFF, OFF, OFF, OFF, OFF, OFF, OFF, OFF
Bit 1~3:
Camera Address setting for VISCA protocol
Bit 4:
Video Color Space
Bit 5:
Reserve
Bit 6:
Reserve for System firmware upgrade
Bit 7~8:
RS-232/RS-422 Baud Rate
1. Camera Address setting for VISCA protocol
When just one camera is used, system takes the camera ID address that is set on Bottom DIP Switch. When more
than one camera is used, cameras will be automatically issued ID addresses by system via VISCA protocol. The ID
address setting on Bottom DIP Switch will be ignored by system.
B1
ON
OFF
ON
OFF
ON
OFF
ON
2. Video Output/Video Color Space
3. Control Setting
In normal use, B6 has to be set to OFF. USB3.0. RS-232, RS-422, RS-485 way of controlling will be recognized by
the camera. B6 ON is only for authorized use.
ON (For Authorized Use ONLY)
B2
OFF
ON
ON
OFF
OFF
ON
ON
B4
OFF
ON
B6
OFF
B3
OFF
OFF
OFF
ON
ON
ON
ON
Color Space Setting
Control Setting
For Normal Use
Firmware Upgrade
18
Address
1
2
3
4
5
6
7
YUV
RGB
Advertisement
Table of Contents
