Table of Contents
Advertisement
•
You can click Adjust button (the button will switch to displaying Stop), and then set the Title position by the
right-side Position adjustment module.
•
It supports two ways to adjust the Title position, by region or by step
•
Adjust by region, you can select from top left, top center, top right, center right, bottom right, bottom center,
bottom left and center left
•
Adjust by step, you can configure a step in the rang from 1 to 100, select the direction, and then click set button
to apply it.
•
After done, please click Stop button to close the 1-Title adjustment
A logo file can be uploaded and overlay onto the IP
video.
1. logo file must be in bmp format;
2. logo file bit depth must be 24;
3. logo file with dimensions 490x480;
4. User can adjust the logo display position by click
the "adjust" button which beside the logo update,
and then use position adjustment module to
adjust the Logo position, the operation is same as
above Title position adjustment.
5. User can adjust the transparency of the logo
display, support 1~100 adjustable percentage;
NOTE: 1 means fully transparent, 100 means
completely opaque.
Camera-Camera Setting- Privacy Mask
The Privacy Mask setting is for adding a Mask of the image pixels that you want to be covered, then the image portion
that has been covered by a mask will not be seen by the viewer.
Only one mask can be added at a time, a total of 24
convex quadrilateral regions are supported.
NOTE: This feature only works with IP stream, will
not affect the SDI, HDMI or other outputs.
You can set up a privacy mask by performing the
followings
1. Click Start Draw button which under the image
window
2. Move your mouse to the camera image window,
select a point and left click mouse to start
3. Then move to a next point and left click mouse,
do in this way multiple times until you can draw
an area that you desire to have.
4. After finish the area drawing, click Add Mask button, it will be done.
14
Advertisement
Table of Contents
