Network-Network Setting-Srt - Bolin Technology EX1000 Series User Manual

Network-Network Setting-SRT

To establish the communication flow, SRT employs a handshake mechanism in which each device is identified as a caller
or listener. In some cases, two devices can negotiate an SRT session in rendezvous mode at the same time.
SRT Mode
Caller
Listener
The Listener device just needs to know that it should listen to the SRT streaming on a specific port
Rendezvous
Camera SRT is set to Off by default, click the drop-down
menu of the Mode option to select a SRT mode.
Mode: User can select from Caller, Listener, Rendezvous
mode, set to Off to disable SRT setting menu.
Caller: SRT Caller mode, the page will expand the caller
mode settings menu, enable Main Stream or Sub Stream as
you want, and configure the corresponding parameters.
•
IP Address: The IP address configured on the
Listener device (if you running a software on the
PC as a Listener device, here to enter the PC's IP
address);
•
Port: Configure a port for SRT session, it must
match the SRT port number of the Listener device
(the range is 1~65535);
•
Stream ID: SRT streaming ID, you can set one or
keep it as default (please configure the same
Stream ID on Listener device);
•
Latency: Delay between the Caller device and
Listener device, can be set from 20~5000ms;
NOTE: When camera set to Caller mode, then the camera can only send SRT stream to one receiver (configured in
Listener mode).
Listener: SRT Listener mode, the page will expand the listener mode settings menu, enable Main Stream or Sub Stream
as you want, and configure the corresponding parameters.
•
Port: Configure a port for SRT session, it must
match the SRT port number of the Caller device
(the range is 1~65535);
•
Stream ID: SRT streaming ID, you can set one or
keep it as default (please configure the same
Stream ID on Caller device);
•
Latency: Delay between the Caller device and
Listener device, can be set from 20~5000ms;
NOTE: When the camera set to Listener mode, multiple
receives (configured in Caller mode) can be allowed to
receive this SRT streaming.
Set the source or destination device as the initiator of the SRT streaming session
The Caller device must know the IP address and port number of the Listener device
Set the device to wait for request to start an SRT streaming session
Allows two devices to use the same port to start an SRT session
Both source and destination must be in Rendezvous mode
What it can do?
18