Important Information
Selecting an input signal
1.
Connect one or more image sources to the projector.
2.
Select the input you want to display:
•
Press one of the input buttons on the remote control.
•
Alternatively, open the On-screen display (OSD) by pressing
main menu, press
buttons. Press
Selecting a test pattern
To display a test pattern:
•
Press
on the remote control. If necessary, press again to change the test pattern. Test
TEST
patterns are displayed in the following order:
Off, White, Black, Red, Green, Blue, CheckerBoard, CrossHatch, V Burst, H Burst,
ColorBar, Pluge
After the final test pattern, the projector exits test pattern mode and returns to the main image. To
view test patterns again, you need to press
•
Alternatively, open the OSD by pressing
then select a test pattern using the
Page 24
and then select an input signal using the
ENTER/OK
to confirm your choice.
ENTER/OK
LEFT
again.
TEST
. Highlight
MENU
Test Patterns
and
arrow buttons.
RIGHT
Digital Projection Titan Laser Series
. Highlight
MENU
and
UP
from the main menu,
Rev A January 2019
from the
Input
arrow
DOWN