Selecting An Input Signal; Selecting A Test Pattern - Digital Projection M-Vision 18K Series Installation And Quick Start Manual

Digital Projection M-Vision Laser 18K Series

Selecting an input signal

1. Connect one or more image sources to the projector.
2. Select the input you want to display:
•
Press one of the input buttons on the remote control.
•
Alternatively, open the On-screen display (OSD) by pressing
select an input signal using the

Selecting a test pattern

To display a test pattern:
•
Press TEST on the remote control.
Change the test pattern using the
White, Black, Red, Green, Blue, Checkerboard, CrossHatch, V Burst, H Burst, ColorBar, Aspect Ratios, Off
•
Alternatively, open the OSD by pressing
RIGHT
and arrow buttons.
After the fi nal test pattern, the projector exits test pattern mode and returns to the main image. To view test patterns again, you need to press
TEST
again. If you wish to exit the test patterns before you reach the fi nal one,
•
TEST EXIT
press or at any time.
Installation and Quick-Start Guide
MENU
UP DOWN
and arrow buttons. Press
LEFT RIGHT
and arrow buttons. Test patterns are displayed in the following order:
MENU Test Patterns
. Highlight
OPERATING THE PROJECTOR
. Highlight Input from the main menu, press
ENTER/OK
to confi rm your choice.
from the main menu, then select a test pattern using the
For full details of how to use the
controls and the menu system, see
the Operating
ENTER/OK and then
LEFT
Notes
Guide.
Rev D October 2019
page 20