Switching The Projector Off; Selecting An Input Signal; Selecting A Test Pattern - Digital Projection M-Vision Laser 21000 WU Important Information Manual

Digital Projection M-Vision Laser 21000 WU

Switching the projector off

1. Press on the remote control or
OFF
your choice.
The indicator on the control panel will start flashing amber, the projected image will turn
POWER
off and the cooling fans will run for a short time until the
indicate that the projector has entered STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the
power connector and then disconnect the power cable from the projector.

Selecting an input signal

1. Connect one or more image sources to the projector.
2. Select the input you want to display:
•
Press one of the input buttons on the remote control.
•
Alternatively, open the On-screen display (OSD) by pressing
main menu, press
buttons. Press

Selecting a test pattern

To display a test pattern:
•
Press on the remote control. If necessary, press again to change the test pattern. Test
TEST
patterns are displayed in the following order:
White, Black, Red, Green, Blue, Checkerboard, CrossHatch, V Burst, H Burst, ColorBar,
Plunge, Off
After the final test pattern, the projector exits test pattern mode and returns to the main image. To
view test patterns again, you need to press
•
Alternatively, open the OSD by pressing
then select a test pattern using the
Rev A November 2018
POWER
and then select an input signal using the
ENTER/OK
to confirm your choice.
ENTER/OK
LEFT
on the control panel, then press again to confirm
POWER
again.
TEST
. Highlight
MENU Test Patterns
and arrow buttons.
RIGHT
Important Information
indicator goes steady red to
. Highlight
MENU Input
and
UP
from the main menu,
from the
arrow
DOWN
Page 19