Ports, Addressing, And Connections - Extron electronics IP Link Pro xi IPL EXP I/O Series User Manual

Mounting to rack rails
using a ZipClip
1.
2.
3.
Furniture mounting
NOTE: The ZipClip is
1.
2.

Ports, Addressing, and Connections

ATTENTION:
Attach cables using the wiring diagrams in this section as a guide. See the
based Configuration and Control
Global Configurator Help File and Toolbelt Help File for information about Global
Configurator and Toolbelt, which you must use to set up the unit.
Fasten the ZipClip 200
mounting clip to a rack
rail using two rack screws
as shown in the diagram
at right.
Insert the bottom of the
EXP down into the clip,
starting with one end.
Pivot the other end
toward the clip and press
until the clip snaps into
place.
shipped with a set of four
wood screws.
Attach the ZipClip to the
mounting surface using two or
more wood screws (see
1
right). Make sure the clip is
oriented with the appropriate
side facing the mounting
surface of the furniture and with
the tab accessible from the
front of the furniture.
Insert the EXP into the ZipClip
as described previously and
2
press to snap it into place.
Installation and service must be performed by experienced personnel.
•
L'installation et l'entretien doivent être effectués par du personnel expérimenté.
•
IPL EXP I/O Series • Hardware Features and Installation
Side of Rack
Inside
Rack
at
1
2
section starting on page 31 and the
ZipClip 200
Back of
Rack
Under a Desk
IPL EXP 200
Software-
13