Table of Contents
Advertisement
LAN/PoE and LAN/PoE+ (Ethernet) connectors and LEDs
To connect the EXP to an Ethernet network (for configuration and control of the EXP
and the devices connected to it), plug a cable into one of these RJ-45 sockets and
connect the other end of the cable to a power inserter, network switch, hub, router, or
PC connected to a local network or the Internet. DHCP is off by default.
•
The IPL EXP RIO8 requires a PoE+ connection through its LAN/PoE+ port see the
power input requirement
•
All other IPL EXP models accept power over Ethernet (PoE) and PoE+ through the
LAN/PoE port
ATTENTION:
Power over Ethernet (PoE) is intended for indoor use only. It is to be connected
•
only to networks or circuits that are not routed to the outside plant or building.
•
L'alimentation via Ethernet (PoE) est destinée à une utilisation en intérieur
uniquement. Elle doit être connectée seulement à des réseaux ou des circuits
qui ne sont pas routés au réseau ou au bâtiment extérieur.
Network Port Addressing:
If you use static IP addresses, configure the settings and IP addresses via Toolbelt. See
the help file for Global Configurator or Toolbelt for basic information on configuration.
See the diagram on the next page and see the following table for default addresses.
Static IP addresses (default, what the unit uses when DHCP is off)
DHCP on (alternative setting)
For details of communication protocols, ports, and services used, see the
Pro Series Control Product Network Ports and Licenses Guide at www.extron.com.
LED Indication:
Activity LED (connectors [all models] and front panel [rack mount models]) —
This yellow LED blinks to indicate network activity.
Link LED (connectors [all models] and front panel [rack mount models]) —
This green LED lights to indicate a good network connection.
100 LED (IPL EXP RIO8 front panel) — This green LED lights when the unit is
connected to a 100 Mbps or faster network connection.
Passwords:
IMPORTANT NOTE:
The factory configured passwords for this device have been set to the device serial
number. Passwords are case sensitive. Performing a Reset to Factory Defaults
reset (see
Resetting the Unit
on page 14).
Network Port Addressing
IP Address
192.168.254.250
DHCP on (addresses are automatically assigned)
on page 29) sets the password to extron.
IPL EXP I/O Series • Hardware Features and Installation
Subnet Mask DNS Address
255.255.255.0 127.0.0.1
18
Advertisement
Table of Contents
