Table of Contents
Advertisement
im Vertrieb von
Installation and Operation, cont'd
5.
Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot
holes in the desk or table at the marked screw locations.
The holes should be drilled from the underside or inside
(concealed side) of the furniture, where the interface will
be located.
6.
Secure the interface to the desk with the provided wood
screws.
7.
To adjust the height of the interface within the desk, slide
the interface up or down to the desired position, then
tighten the screws that attach the brackets to the interface.
Rack mounting
1.
If feet were installed on the bottom of the interface,
remove them.
2.
Place the interface on one half of the 1U (one unit high,
19" wide) optional rack shelf (part #60-190-01). Align the
front of the interface with the front of the shelf, and align
the threaded holes on the bottom of the interface with the
holes in the rack shelf (figure 2-5).
3.
Secure the interface to the rack shelf with the two
provided 4-40 x 3/16" machine screws. Insert the screws
from the underside of the shelf and securely fasten them
through diagonally opposite corners as shown in
figure 2-5.
4.
Fasten the false front panel (provided with the rack shelf)
to the unoccupied side of the rack (figure 2-5), or install a
second half-rack-width device in that side by repeating
steps 1 through 3.
5.
Secure the rack shelf to the rack using four 10-32 x ¾" bolts.
Insert the bolts through #10 beveled washers, then through
the holes in the rack ears.
www.camboard.de
2-8
RGB 203 Rxi, RGB 203 Rxi VTG • Installation and Operation
CAMBOARD Electronics
Rear Panel Connections and Switches
100-240
50/60 Hz
Tel. 07131 911201
RGB 203 Rxi, RGB 203 Rxi VTG • Installation and Operation
Fax 07131 911203
False Front panel
uses 2 front holes
LE
VE
L
PE
AK
BO
O ST
CE
NT
ER
CO
IN G
NT
RO
L
M IN
SX
I VT
G A
G
VG
XG
A
A
20
3
R G
B
SV
2 0
G A
3 x
VT
i V
G
T G
W IT
H AD
SP
IN PU
TM
T
1
2
3
Figure 2-5 — Rack mounting
Figure 2-6 shows the rear panel of the RGB 203 Rxi. The
features described in this section apply to both models.
1
2
1
0.2A
INPUT 1
INPUT 3
AUDIO
AUDIO
INPUT 2
MONITOR
8
1
2
3
6
Figure 2-6 — RGB 203 Rxi rear panel features
Inputs 1, 2, and 3 — Connect the analog computer-video
1
sources to these 15-pin HD female connectors.
ce-info@camboard.de
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16" Screws
7
REMOTE
R
G
B
H
V
S
L/MONO
R
OUTPUTS
4
5
2-9
Advertisement
Table of Contents
