Extron electronics IP Link Pro xi IPL EXP I/O Series User Manual page 36

See the following diagram as an example of a system where both an EXP and a
supplemental power supply are included in the eBUS topology.
EBDB MINI
Rear Panel
(or use
an EBDB
10-port hub)
ATTENTION:
• Do NOT connect the power pin
to any device that is already
powered by the IPL EXP or an
IPCP control processor or by
an additional power supply.
• NE connectez PAS la broche
d'alimentation à un appareil
déjà alimenté par le IPL EXP
ou le processeur de contrôle
IPCP ou par une autre source
d'alimentation.
Figure 17.
eBUS DISTRIBUTION HUB
• Connect up to four (4) eBUS devices to the
+ V + S - S G + V + S - S G + V + S - S G
• Wire the connectors the same at both ends.
X
+S -S G +V +S -S G +V +S -S G
+V
+S
-S
IPL EXP
Rear Panel
Powered
+S -S G
eBUS
device(s)
Tie drain wires to ground.
Connecting eBUS Devices in a System With Both an EXP and
Another Powered eBUS Device
IPL EXP I/O Series • Hardware Features and Installation
eBUS Connections
eBUS distribution hub (EBDB MINI).
3/16" (5 mm) Max.
+12 VDC
+ Signal
- Signal
G Ground
Tie drain wires to ground.
eBUS (PWR 3W)
+V +S -S G
+V +S -S G
eBUS port on an
EBP or other
eBUS device
28