Table of Contents
Advertisement
im Vertrieb von
Troubleshooting
Power connections
Network connections
www.camboard.de
CAMBOARD Electronics
4.
If passwords were set up for the connected system, you are prompted to log
in as an administrator or a user. Otherwise the system responds with a
carriage return and line feed (<cr/lf>).
5.
Once you are connected, you can enter SIS commands as desired.
6.
When you are finished entering commands to the interface, enter Ctrl + ] at
the command prompt to exit Telnet.
Turn on the equipment in the following order:
1.
The PCS4 power control interface
2.
The power receptacles on the PCS4
3.
The connected output device(s)
If the output A/V device cannot be powered on, check the following:
1.
Make sure that the receptacle for each device is receiving power. The
receptacle's red Power LED lights if the receptacle is powered on. If
necessary, press the receptacle button to apply power.
2.
Ensure that all devices are plugged in properly to the rear panel of the PCS4
and switched on if applicable.
1.
Check the network connections and make adjustments as needed. The Link
LED is solid green if a network connection is detected. The yellow ACT
LED blinks if there is activity on the network. If these LEDs are not lit,
either the cable is faulty or not plugged in, or the wrong type of cable is
being used (refer to Connecting the Hardware, in chapter 2).
2.
At the DOS command prompt, try to ping the unit by entering ping and the
IP address assigned to your PCS4. (See Setting up and configuring the PC
using ARP, in chapter 4.) If the PCS4 is connected, you receive the following
response to your Ping command:
Successful Ping command response
Tel. 07131 911201
IPL T PCS4 • Web Page-Based Setup and Control
Fax 07131 911203
ce-info@camboard.de
4-27
Advertisement
Table of Contents
