Table of Contents
Advertisement
Panel Features
This section describes:
•
•
TLSI 201 Rear Panel Features and Connections
Figure 2.
A
B
C
D
TLSI 201 Rear Panel Features and Connections
TLSI 201 Front Panel Features
INPUT
OUTPUT
A A A
B B B
TLSI 101 Rear Panel
HDMI Input — At present, this port is not used by the TLSI 201.
HDMI Output — Connect this female HDMI type A connector to a third-party touch
screen. Use the provided LockIt HDMI lacing bracket to secure the HDMI connector
(see
Securing the HDMI Connector
The TLSI 201 supports an output resolution of 1080p.
USB Control Port — Supports High-speed USB 2.0 control. Plug a USB cable from
the third-party touchpanel into this female type B connector.
The USB connection passes information to the TLSI 201 about where on the screen the
third-party touch display was pressed. If you are using a non-touch display, connect a
USB mouse to the USB port on the TLSI 201 and use the mouse to click screen icons.
LAN/PoE+ Port — Connect the interface to the LAN using a twisted pair cable,
terminated with an RJ-45 connector. Use a straight-through Ethernet cable to
connect the panel to a switch or router. Use a crossover cable to connect the panel
directly to a computer.
ATTENTION:
Do not power on the interface until you have read the
•
page 7.
Ne branchez pas l'interface avant d'avoir lu les
•
The network port has two LEDs. The green Link LED lights
steadily to indicate that the interface is connected correctly
to a network. The amber Activity LED blinks to indicate that
data is being passed to or from the interface.
These interfaces are compliant with the requirements of PoE+ (IEEE 802.3at) and
must be powered by PoE+ power sourcing equipment (PSE). This can be a power
injector (see
figure 3
on page 6) or PoE+ switch.
PoE+ PSE must be purchased separately.
NOTE:
The
DEVICE
C C C
on page 8).
mises en garde
TLSI 201 • Panel Features
LAN/PoE +
D D D
Attention
notice on
page 7.
LAN
Activity LED
RJ-45 Port
Link LED
5
Advertisement
Table of Contents
