Table of Contents
Advertisement
Rack Mounting
The IPL EXP units are one quarter rack wide.
Up to four IPL units can be
mounted side by side directly
onto a rack shelf.
1.
Align the threaded holes in
the bottom of the IPL EXP
with the holes in an Extron
rack shelf and fasten the unit
to the shelf with two
4-40 x 3/16"inch screws
(see
1
2.
Bolt the rack shelf to the
rack (see
Mounting an IPL EXP Expansion Interface With a ZipClip 200
These instructions apply to the IPL EXP 200, S5, and S2 models.
Using the ZipClip 200
Attaching and removing the clip and IPL EXP
To attach the EXP to the ZipClip 200 mounting clip:
1.
Insert the bottom of the EXP down into the clip, starting with one end.
2.
Pivot the other end down and press until the clip snaps into place.
To remove the EXP from the ZipClip:
1.
Press the tab on the ZipClip (see
at right).
2.
Pivot the EXP and lift it out of the
ZipClip (see
Using tie wraps
for cable strain relief
1.
Attach the EXP to the ZipClip 200 mounting clip as described previously.
2.
Fasten the cables to the ZipClip base.
a.
Insert tie wraps (also called
"zip ties") along the notches
on the side of the EXP and
through the tie wrap anchor
points on the ZipClip, then
around the cables.
b.
Connect and pull the tie
wraps until they are secure.
Do not over-tighten.
2
at right).
).
2
1
).
2
IPL EXP I/O Series • Hardware Features and Installation
1
(2) 4-40 x 3/16"
Screws
On a Rack Shelf
2
1
RSB 123
Rack Shelf
Tie Wrap
12
Advertisement
Table of Contents
