Cleaning The Device; Cleaning The Magazines; Preventive Maintenance; Troubleshooting - 3DHISTECH PANNORAMIC SCAN RX 1.1 User Manual

PANNORAMIC® SCAN RX 1.1

9.3.1 Cleaning the device

•
Before cleaning, switch off the device and pull the plug out.
•
Do not let liquid penetrate into the system.
•
To clean liquid from the device, use a lint-free cotton cloth. You can moisten the cloth
with water.
•
To clean greasy surfaces, it is recommended to apply soapy water on a piece of lint-free
cotton cloth and gently rub the surface.

9.3.2 Cleaning the magazines

NEVER clean the magazines with Xylene because it might harm the plastic. We recommend
applying Isopropanol on a piece of lint-free cotton cloth and gently rub the surface instead.
In case the magazine is damaged, use either order a new one, as inserting a deteriorated
magazine could lead into unsafe loading of slides.

9.3.3 Preventive maintenance

To prevent fungus growth
•
Do not leave the equipment in an unconditioned environment with a storage
temperature above 60°C (140°F) or below 0°C (32°F), which may damage the equipment.
•
Maximum operating temperature is 35°C (95°F) with a relative humidity of less than 75%.
•
Install it in a room with proper air ventilation.
•
Do not let dust or fingerprints remain on optical surfaces.

9.4 Troubleshooting

This chapter describes the most common troubleshooting solutions for the Pannoramic®
SCAN RX product. If any problem arises that does not have solution in this manual, contact
3DHISTECH service support at
The product does not start.
•
Power supply is interrupted.
1.
Make sure that the 24V external power supply is on.
2.
Check cable connections.
Pannoramic® Scanner Software for Research control software has stopped.
•
Slide jammed
1. Exit control software.
NOVEMBER 18, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES.
support@3dhistech.com
TROUBLESHOOTING AND MAINTENANCE
.
149