Connectors And Cables - 3DHISTECH PANNORAMIC SCAN RX 1.1 User Manual

PANNORAMIC® SCAN RX 1.1

2.3 Connectors and cables

For the required cable connections, the supplied cables must be connected.
Warning!
All cable connections must be checked for firm seating. Defective cables must not be
connected to any part and must be replaced with cables in proper operating condition.
Contact 3DHISTECH Support for help in such cases.
Caution!
It is not recommended to use USB and FireWire cables longer than 2.5 meters.
•
Control – USB (between scanner and control computer)
•
Preview camera – USB cable (between scanner and control computer)
•
Point Grey Grasshopper 3 – USB 3.0 cable (between Point Grey Grasshopper 3
camera and control computer)
•
pco.edge 4.2 bi – a pair of CameraLink cables (between pco.edge 4.2 bi camera
and control computer)
•
Video cable (between monitor and control computer)
•
Power supply cable (between 230V/110V and monitor)
•
Power supply cable (between 230V/110V and Lumencor SPECTRA 6 unit)
•
Power supply cable (between 230V/110V and control computer)
•
Power supply cable (between 230V/110V and 24V external power supply unit)
•
Power supply cable (between 230V/110V and Lumencor SOLA U-NIR fluorescent
illumination unit)
•
Power supply cable (between 230V/110V and pco.edge 4.2 bi camera)
•
Optical cable (between Lumencor SOLA U-NIR fluorescent illumination unit and
scanner)
•
Trigger cable (between pco.edge 4.2 bi and Lumencor SPECTRA 6 fluorescent
illumination unit)
•
USB-to-RS232 serial communication cable (between Lumencor SPECTRA 6
fluorescent illumination unit and control computer)
NOVEMBER 18, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES.
INSTALLATION
27