Cleaning The Device; Cleaning The Magazine - 3DHISTECH Pannoramic 250 FLASH III User Manual

Pannoramic 250 FLASH III 3.0.2 User's Guide
The product is not equipped with protection against hazardous materials (infectious, toxic,
radioactive, corrosive substances or other effects damaging to health). Decontaminate infectious
materials after use.
Dust, specks and humidity may decrease or harm the operating capability of the device. Protect it
with dust cover when not in use. Switch the power off before covering it.
There is crush hazard during operation in the area of input or output. Inserts/magazines should be
moved through software. The protective shield of the magazine feed unit can be unmounted when
slide scanning has stopped. The device can be opened for service reasons only when switched off,
and in cases stated in this User's Guide (for example, changing filters).
Defective devices do not classify as domestic waste. Dispose of the device in compliance with the
currently valid legal requirements.
Lumencor SPECTRA 6 illumination unit
NEVER switch on the Lumencor SPECTRA 6 light source when it is not mounted to the
•
microscope.
Do not cover the unit, as it would cause abnormal temperature rising.
•
Ensure that the light source is mounted well and the fixing lever is closed.
•

7.2.1 Cleaning the device

Before cleaning, switch off the device and pull the plug out.
•
Do not let liquid penetrate into the system.
•
To clean liquid from the device, use a lint-free cotton cloth. You can moisten the cloth with
•
water.
To clean greasy surfaces, it is recommended to apply Isopropanol or Ethanol on a piece of
•
lint-free cotton cloth and gently rub the surface.

7.2.2 Cleaning the magazine

Do not clean the magazines with xylene, because it might harm the plastic. We recommend to apply
Isopropanol on a piece of lint-free cotton cloth and gently rub the surface instead. In case the
magazine is damaged, use either order a new one, as inserting a deteriorated magazine could lead
into unsafe loading of slides.
September 16, 2020 – Rev. 1 3DHISTECH Ltd.
7 Troubleshooting and Maintenance
138(156)