Using Profiles - 3DHISTECH PANNORAMIC SCAN RX 1.1 User Manual

PANNORAMIC® SCAN RX 1.1

8 Using Profiles

Notice:
Saved profile settings cannot be applied if using a different type of Pannoramic® scanner.
If you want to scan a group of slides, it is advised to save your settings previously in a
profile and continue scanning in Automatic mode. You can save the following settings in a
profile:
Scan Mode
•
Brightfield
•
Fluorescent
Scan Options
•
Focus frequency (in Fluorescent mode)
•
Focus frequency (in Brightfield mode)
•
Compression procedure
•
Use of a fixed compensation image (in Brightfield mode – ON/OFF)
•
Use of Save focus quality (ON/OFF)
•
Use of Stitching (ON/OFF)
Determination of the area to be scanned
•
Use of automatic threshold specimen
•
Use of specimen threshold value
•
Use of marker pen threshold and specimen threshold values
•
Remove coverslip function (ON/OFF)
•
Use of scan everything within marked area (ON/OFF)
•
Filling of holes (ON/OFF)
•
Use of removing specks according to the set value (ON/OFF)
•
Use saved scan area
•
Use selection box (ON/OFF)
NOVEMBER 18, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES.
USING PROFILES
140