3DHISTECH PANNORAMIC SCAN RX 1.1 User Manual page 119

PANNORAMIC® SCAN RX 1.1
Slide settings
o Unload slide after FL grabbing (N/A)
o Slide label anonymity – Slide label area is displayed as a clear white image during
scanning, patient data will not be visible in CaseViewer or SlideViewer.
o
Do not save label to slide – The original label area is not saved to the slide and will
not be visible in CaseViewer or SlideViewer.
o Calculate exposure time for barcode grabbing – Three images are recorded for
barcode image creation. Exposure times will be recalculated each time, thus
creating prefect light conditions for barcode reading, so to make sure that
barcode identification is successful.
o Rotate barcode image by 180° degrees
o Unload slide after planner scan
o
Enable reloading of magazines with same slide set
o Automatic empty slide position detection – Slide positions of the magazines to
which slides are not loaded into will be detected by the software, and slides
without including any marking/etching/label on the label area will be classified as
slides to skip. Upon selecting a position where slide could not be detected, the
following messages appears:
Notice:
This feature can be enabled only if no slide is loaded in the stage. By enabling it once there
are slides already been loaded into the microscope since Pannoramic® Scanner Software for
Research control software was started, those slides will not be re-considered as slides to
skip.
NOVEMBER 18, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES.
SETTINGS AND SERVICES
118