3DHISTECH PANNORAMIC SCAN RX 1.1 User Manual page 107

PANNORAMIC® SCAN RX 1.1
Take all previews – Preview images of all the slides in the magazine are taken automatically.
Select the required preview type from the following (from top to bottom): Brightfield, Pre-scan,
Pre-scan high-resolution, Pre-scan + high-resolution.
By clicking Take all previews, the scanner records all the preview images taken of all the slides
that are loaded into the device. If there are at least two racks added in Planner and Enable
reloading of magazines with same slide set function in Preferences / Slide settings is turned on,
will the Take all previews for all Racks function be enabled, with which all the slides in the added
racks will be loaded for preview taking purposes.
If you want to retake the preview of the actually loaded slide, the Retake Preview function is
available from the Quick Toolbar of the preview window. Activate Retake Preview for all the
slides in the magazine if necessary. This operation can be initiated from the slide preview window
as well.
Load / Save Plan menu – Opens a drop-down menu including the following:
•
Load plan – The previously saved scanning plan can be loaded.
•
Save plan – A scanning plan containing all parameters and profile assignment will be
saved.
•
Load CSV – Rack number, slide position, slide name, barcode (optional), profile name,
illumination type data from a CSV file can be loaded.
Notice:
With the Barcode parameter in the CSV file the barcode of the slide can be specified, but this
parameter is optional and does not need to be specified.
Warning!
To prevent case mix-up, ALWAYS pay special attention when entering barcodes manually, as
the slide will be identified based on the barcode specified in the CSV file.
NOVEMBER 18, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES.
Figure 97. Take all preview selector
SCANNING MODES AND SETTINGS
106