PANNORAMIC® SCAN RX 1.1
2.6 External power supply unit
For the proper operation of the scanner, the SINPRO – MPU101-108 24V external power
supply unit must be connected between the mains power and the device.
Front panel:
1.
main power switch
2.
power supply connector
Back panel:
3.
detachable power cord to connect the external power supply unit with the main
unit
2.7 Power the scanner on/off
To turn the scanner on, press down the I side of the rocker switch at the front panel of the
24V external power supply unit (Figure 6 – 1), and press O to power the scanner off.
NOVEMBER 18, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES.
Figure 6. 24V external power supply unit
INSTALLATION
29