13.7 Emergency mode
13.7.1 Activating emergency mode
Required:
Emergency-Key (must be authorised for the locking device beforehand)
l
Procedure:
Steps
1. Hold the Emergency-Key in the reading field of the locking device for approx. 1 second.
The Emergency-Key is read and accepted.
2. Remove the Emergency-Key from the reading field of the locking device.
The locking device is now in emergency mode. Access is now permanently possible without
the locking media since the locking device remains permanently uncoupled. Emergency
mode can only be deactivated again by an Emergency-Key.
Troubleshooting:
Signal
1x
long red
RFID furniture lock
Cause
The Emergency-Key could be read but is not authorised for this
locking device.
13.7 Emergency mode
Signal
1x
short green
Solution
Authorise the
Emergency-Key.
Page 73 of 84