CEStronics OMEGA FLEX Assembly And Operating Manual page 61

Steps
1. Hold the System-Master for roughly 1 second in the reading field of the locking device.
'Authorisation mode' has been started.
2. Now you can authorise any number of master media in succession by holding each master
medium in the reading field of the locking device for about 1 second.
The master medium has been authorised.
3. Hold the System-Master in the reading field of the locking device for approx. 1 second to
end 'Authorisation mode'.
'Authorisation mode' has been terminated.
'Authorisation mode' is terminated automatically after approx. 5 seconds. The new
authorisations remain stored.
All master media that were held in the reading field are now authorised to implement
settings for this locking device.
Troubleshooting:
Signal
After step 2:
1x long red
RFID furniture lock
Cause
The master medium could be read
but could not be authorised:
a) You have tried to authorise a
Program-Master for a V-NET locking
device.
b) The master medium has the
wrong system number
c) You have used a locking medium
instead of a master medium.
d) You have tried to authorise an
RF-Trace-Master or an RF-Ini-
Master.
13.2 Authorising additional master media
Signal
1x short green
1x short green
ter medium
1x long green
Solution
a) Program-Masters cannot be authorised for V-NET
devices.
b) Use a master medium with the correct system
number.
c) Use a master medium.
d) RF-Trace-Masters and RF-Ini-Masters cannot be
authorised.
after each mas-
Page 61 of 84