Analog Devices ADSP-BF506F EZ-KIT Lite Manual page 35

The LED and push button signals also are connected to the expansion
interface II; see
page 2-18 and
JTAG Interface
The board contains an on-board debug agent that operates via a USB port.
The ADSP-BF506F EZ-KIT Lite receives all of its power via USB; there-
fore, no power supply is required.
For debugging, the JTAG connector (
(USB-ICE or HPUSB-ICE) to connect to the board, instead of the
on-board debug agent.
For more information about emulators, contact Analog Devices or go to:
http://www.analog.com/processors/tools/blackfin
Expansion Interface II
The expansion interface II allows an Analog Devices EZ-Extender
custom-design daughter board to be tested across various hardware plat-
forms that have the same expansion interface.
The expansion interface II implemented on the ADSP-BF506F EZ-KIT
Lite consists of three connectors, which are 0.1 in. shrouded headers (
). The connectors contain a majority of the ADSP-BF506F processor's
4
signals. For pinout information, go to
matic" on page
connectors can be obtained by contacting
For more information about daughter boards, visit the Analog Devices
Web site at:
http://www.analog.com/processors/tools/blackfin
ADSP-BF506F EZ-KIT Lite Evaluation System Manual
"Expansion Interface II Connectors (P2 and P4)" on
"Expansion Interface II Connector (P3)" on page
B-1. The mechanical dimensions of the expansion
Using ADSP-BF506F EZ-KIT Lite
) allows an external emulator
P1
.
"ADSP-BF506F EZ-KIT Lite Sche-
"Technical Support".
.
2-18.
®
or a
P2–
1-15