Analog Devices ADSP-BF506F EZ-KIT Lite Manual page 23

Default Configuration
The EZ-KIT Lite evaluation system contains ESD (electrostatic discharge)
sensitive devices. Electrostatic charges readily accumulate on the human body
and equipment and can discharge without detection. Permanent damage may
occur on devices subjected to high-energy discharges. Proper ESD precau-
tions are recommended to avoid performance degradation or loss of function-
ality. Store unused EZ-KIT Lite boards in the protective shipping package.
The ADSP-BF506F EZ-KIT Lite board is designed to run outside your
personal computer as a standalone unit.
When removing the EZ-KIT Lite board from the package, handle the
board carefully to avoid the discharge of static electricity, which can dam-
age some components.
switches, connector locations, and LEDs used in installation. Confirm
that your board is in the default configuration before using the board.
CCES Install and Session Startup
For information about CCES and to download the software, go to
www.analog.com/CCES
Support Package (BSP) for CCES can be found at
http://www.analog.com/Blackfin/EZKits
Follow these instructions to ensure correct operation of the product soft-
ware and hardware.
Step 1: Connect the EZ-KIT Lite board to a personal computer (PC) run-
ning CCES using one of two options: an Analog Devices emulator or via
the debug agent.
ADSP-BF506F EZ-KIT Lite Evaluation System Manual
Using ADSP-BF506F EZ-KIT Lite
Figure 1-1 shows the default jumper settings,
. A link for the ADSP-BF506F EZ-KIT Lite Board
.
1-3