Table of Contents
Advertisement
246
STARTING AND OPERATING
E
A
D
NABLING
ND
ISABLING
ParkSense can be enabled and
disabled with the ParkSense switch,
located on the switch panel below the
climate controls.
ParkSense Switch
When the ParkSense switch is pushed to
disable the system, the instrument cluster
display will show the "PARKSENSE OFF"
message for approximately five seconds. Refer
to "Instrument Cluster Display" in "Getting To
Know Your Instrument Panel" for further
information. When the gear selector is moved to
REVERSE and the system is disabled, the
instrument cluster display will show the
"PARKSENSE OFF" message for as long as the
vehicle is in REVERSE (Not in 4L).
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed, and requires service, the ParkSense
switch LED will blink momentarily, and then the
LED will be on.
P
S
S
T
ARK
ENSE
ERVICE
A
S
SSIST
YSTEM
During vehicle start up, when the ParkSense
Rear Park Assist System has detected a faulted
condition, the instrument cluster display will
actuate a single chime, once per ignition cycle,
and it will display the "PARKSENSE
UNAVAILABLE WIPE REAR SENSORS" or the
"PARKSENSE UNAVAILABLE SERVICE
REQUIRED" message. Refer to "Instrument
Cluster Display". When the gear selector is
moved to REVERSE and the system has
detected a faulted condition, the instrument
cluster display will show the "PARKSENSE
UNAVAILABLE WIPE REAR SENSORS" or
"PARKSENSE UNAVAILABLE SERVICE
REQUIRED" message for as long as the vehicle
is in REVERSE. Under this condition, ParkSense
will not operate.
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" appears in the instrument cluster
display, make sure the outer surface and the
underside of the rear fascia/bumper is clean
and clear of snow, ice, mud, dirt or other
obstruction and then cycle the ignition. If the
message continues to appear, see an
authorized dealer.
P
S
R
P
HE
ARK
ENSE
EAR
ARK
If "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" appears in the instrument cluster
display, see an authorized dealer.
C
T
P
S
LEANING
HE
ARK
ENSE
Clean the Rear Park Assist sensors with water,
car wash soap and a soft cloth. Do not use
rough or hard cloths. In washing stations, clean
sensors quickly keeping the vapor jet/high
pressure washing nozzles at least 4 inches (10
cm) from the sensors. Do not scratch or poke
the sensors. Otherwise, you could damage the
sensors.
P
S
S
U
ARK
ENSE
YSTEM
SAGE
P
RECAUTIONS
NOTE:
Ensure that the rear bumper is free of snow,
ice, mud, dirt and debris to keep the Park-
Sense system operating properly.
Jackhammers, large trucks, and other vibra-
tions could affect the performance of Park-
Sense.
S
YSTEM
Advertisement
Table of Contents
